FIPS 140-2 Validation Certificate The National Institute of Standards and Technology of the United States of America · The Communications Security Establishment of the Government of Canada Certificate No. 1144 The National Institute of Standards and Technology, as the United States FIPS 140-2 Cryptographic Module Validation Authority; and the Communications Security Establishment, as the Canadian FIPS 140-2 Cryptographic Module Validation Authority; hereby validate the FIPS 140-2 testing results of the Cryptographic Module identified as: Apollo OS V4.03 on SLE66CX680PE m1534-a13 by SCsquare Ltd. (When operated in FIPS mode) in accordance with the Derived Test Requirements for FIPS 140-2, Security Requirements for Cryptographic Modules. FIPS 140-2 specifies the security requirements that are to be satisfied by a cryptographic module utilized within a security system protecting Sensitive Information (United States) or Protected Information (Canada) within computer and telecommunications systems (including voice systems). Products which use the above identified cryptographic module may be labeled as complying with the requirements of FIPS 140-2 so long as the product, throughout its life cycle, continues to use the validated version of the cryptographic module as specified in this certificate. The validation report contains additional details concerning test results. No reliability test has been performed and no warranty of the products by both agencies is either expressed or implied. This certificate includes details on the scope of conformance and validation authority signatures on the reverse. TM. A CertlflC81lon Mark or NIST, which does nollmply product endorsement by NIST, the U.S., or Canadian GovernmenlS. FIPS 140-2 provides four increasing, qualitative levels of security: Level 1, Level 2, Level 3, and Level 4. These levels are intended to cover the wide range and potential applications and environments in which cryptographic modules may be employed. The security requirements cover eleven areas related to the secure design and implementation of a cryptographic module. The scope of conformance achieved by the cryptographic modules as tested in the product identified as: Apollo OS V4.03 on SLE66CX680PE m1534-a13 by SCsquare Ltd. (Firmware Version: 4.03; Firmware) TUViT GmbH, Evaluation Body for IT Security, NVLAP Lab Code 200636-0 and tested by the Cryptographic Module Testing accredited laboratory: CRYPTIK Version 7.0 is as follows: -------------------------- Cryptographic Module Specification: Level 3 Cryptographic Module Ports and Interfaces: Level 3 Roles, Services, and Authentication: Level 3 Finite State Model: Level 3 Physical Security: Level 3 Cryptographic Key Management: Level 3 (Single Chip) EMlfEMC: Level 3 Self-Tests: Level 3 Design Assurance: Level 3 Mitigation of Other Attacks: Level 3 Operational Environment; Level N/A tested in the following configuration(s):SLE66CX680PE m1534-a13 smart card controller IC The following FIPS approved Cryptographic Algorithms are used: Triple-DES (Cert. #701); DSA (Cert. #306); SHS (Cert. #839); RNG (Cert. #483); RSA (Cert. #406); HMAC (Cert. #464) The cryptographic module also contains the following non-FIPS approved algorithms: ECDSA (non-compliant) Overall Level Achieved: 3 Signed on behalf of the Government of the United States Signed on behalf of the Government of Canada Signature: W~ \==~~ Signature: ~~IrZ